Mountain Metrology Presents Electrical Calibration.

 

ABOUT US    Electrical Calibration     Gage Block Comparator System     Ring Comparator System     Surface Plate Level System    

 

Certificate of Calibration     Mechanical Calibration System      More Services    HOME

No stone is unturned when it comes to the calibration of our customer’s equipment.  With a staff of highly trained technical and state of the art equipment, ever detail in the service of your equipment is checked.  Calibration procedures used are the same as those imposed by the U.S. Department of Defense to insure that your equipment receive the most stringent tests in verifying instrument accuracy.  And if you the require special testing requirements and/or prefer that of the Original Equipment Manufacture, all that’s necessary is for us to be advised of that requirement.     

With replacement cost of test and measuring equipment skyrocketing, we also offer a cost effective option or approach in the repair of your instrument.  We will assess and evaluate your equipment to re-certify its performance that of the original equipment manufactures specification.  This evaluate allows us to identify and provide to our customers a quotation noting parts, labor and lead-time for customer approval prior to any work being preformed.  If after your evaluation you determined that replacement is your best option, your only cost would be that of an evaluation fee.

 

We use an Electrical Calibration System, which consists of:           

  • Fluke 5700A Multifunction Calibrator (6PPM DC Accuracy)                       

  • Fluke 5220A Transconductance Amplifier (0 to 20 Amp)                       

  • Tektronix CG5001 Calibration Generator (Scopes to 1 GHZ)                       

  • Micro-Tel 1295 Precision Attenuation Measurement  (Range to 40 GHZ)                       

  • Fluke 6060B Signal Generator (Frequency to 1 GHZ)                       

  • Fluke 2189A PRT Thermometer (.02°C Accuracy)                       

  • Fluke 2190A Thermocouple Thermometer (.2°C Accuracy)                       

  • ESI 707B-DL Capacitance Bridge (.01% Accuracy)                       

  • EIP 548A/W-36 Frequency Counter  (10 Hz to 26.5 GHz)                

  • Hewlett Packard 8569B/e43 Spectrum Analyzer (10MHz to 44 GHz)                       

  • Hewlett Packard 8620C/86290B-H08 Sweep Oscillator (Range to 22 GHz)

  • ESI 2420 Precision Resistance Measuring System                      

  • And more

 

These systems allow us to calibrate most instrumentation. 

 This means:         

Data is Available On Request

Consistent Testing

Assured Accuracy

 

Compliance with ANSI/NCSL-Z540-1

 

 

Please give us a call at (719) 442-0004 today!

or

toll free 1-888-442-0007

 

FAX or Email us at (719) 442-0006

www.mountainmetrology.com